Program to decode radio transmissions from devices on the ISM bands (and other frequencies)
- rtl-sdr
- sdr
- signal-processing
- 433mhz
132,241 visible repositories in the index
1–15 of 15 · Most stars
Program to decode radio transmissions from devices on the ISM bands (and other frequencies)
Transmits AM radio on computers without radio transmitting hardware.
open-source IEEE 802.11 WiFi baseband FPGA (chip) design: driver, software
digital signal processing library for software-defined radios
Dire Wolf is a software "soundcard" AX.25 packet modem/TNC and APRS encoder/decoder. It can be used stand-alone to observe APRS traffic, as a tracker, digipeater, APRStt gateway, or Internet Gateway (IGate). For more information, look at the bottom 1/4 of this page and in https://github.com/wb2osz/direwolf/blob/dev/doc/README.md
Ham Radio All-in-one-Cable
ESP-SDR uses the undocumented raw I/Q capture functionality of ESP32 family chips to turn them into (low-duty-cycle) Software Defined Radios
The repository host gives no description.
Dump1090 is a simple Mode S decoder for RTLSDR devices
:airplane: Multi-functional, compatible DIY general aviation proximity awareness system
library for turning a RTL2832 based DVB dongle into a Software DefinedReceiver; mirror from https://gitea.osmocom.org/sdr/rtl-sdr
general-purpose software audio FSK modem
Driver/HAL to build a gateway using a concentrator board based on Semtech SX1301 multi-channel modem and SX1257/SX1255 RF transceivers.
Ultra-minimal, zero-CPU 5.8 GHz analog FPV video receiver using ESP32-C5 Wi-Fi 6 PHY MODEM_DIAG, BitScrambler WBFM demodulation & resistor DAC CVBS
Experimental LR2021 raw I/Q capture library and tools in C.