65,764 visible repositories in the index
1–9 of 9 · Most stars
Marlin is a firmware for RepRap 3D printers optimized for both 8 and 32 bit microcontrollers. Marlin supports all common platforms. Many commercial 3D printers come with Marlin installed. Check with your vendor if you need source code for your specific machine.
An open source, embedded, high performance g-code-parser and CNC milling controller written in optimized C that will run on a straight Arduino
An open source, embedded, high performance g-code-parser and CNC milling controller written in optimized C that will run on a straight Arduino
3D reproduction of TSA Master keys
FW for ESP8266/ESP8285/ESP32 used with 3D printer
Build your own robot duck. XGO-Duck is a 3D-printable biped powered by Arduino UNO Q and 15 servos, adapted from Pollen Robotics' Microduck. Includes mechanical models, PCB designs, a BOM, and an assembly guide. Build it, explore its motion, and make it your own.
Translated🦆 Feetech HD1910 Microduck replica: one-legged balance, ready-to-use models, Chinese console, custom HAT/IMU & 3-step build guides. No training required.
Print wirelessly from Cura, PrusaSlicer or Slic3r to your 3D printer connected to an ESP8266 or ESP32 module
Ultra-low-cost robotic joint: a $1.5 FOC board inside a 1503 gimbal motor, plus a 3D-printed high-ratio precision gearbox. Cheap power, exact motion.